Sep 05, 2019 Front tire: 4.00x15: 2WD Rear tire: 8.3x16: full dimensions and tires. John Deere 755 attachments: mowing deck: front-end loader: backhoe: all 755 attachments. 755 Serial Numbers: Location: Serial number plate located below the rear PTO shaft. 1986: M03: M04: M04: M06: M0: M01. John Deere 655 755 855 955; John Deere 655 755 855 955. Products 42 Sort by: 1 2 Next Page View All. John Deere Snow Blade Runners (4) $33.78. 50 inch Deck Gator Mulching G6 Blade Set (3 Blades) (6) $47.01. 72 Inch Deck Gator Mulcher G6 Blade Set (3 Blades).
- At The Repair Manual we provide quality Repair and Service Manuals for John Deere. The brand name of Deere & Company is an American corporation that manufactures agricultural, construction, and forestry equipment’s, diesel engines, drivetrains (axles, transmissions, gearboxes) used in heavy equipment, and lawn care equipment.
- John Deere PDF Tractor Workshop and Repair manuals. John Deere Automobile Parts. User manual PDF John Deere 335D,John Deere 437D, John Deere CD4039DF008,John Deere PC20864,John Deere 444J,John Deere 4420. Oil change in the front PTO housing (if available). 1500 hours.
Service Transmission
Checking The Front Axle Oil Level
Service Interval: Visually check front axle oil level every 50 hours.
IMPORTANT: Avoid damage! Allow front axle oil time to cool before checking level. |
1. Park tractor on level surface. Engage park brake.
2. Lower attachments and stop engine.
3. Unscrew dipstick (A) located inside right front wheel and remove it from axle.
M99182
4. Wipe dipstick dry, insert dipstick into axle hole but DO NOT screw it into the axle case. Remove dipstick.
5. Oil level should be to top mark (B) on dipstick.
MIF
6. If oil level is low, pour oil into the dipstick opening. Use John Deere API GL-5 Gear Oil or its equivalent.
7. Allow oil at least one hour to settle. Oil level should be to the top mark (B) on the dipstick.
8. Install and tighten dipstick. Check again after the first several hours of operation.
755 John Deere Front Axle Parts Manual Parts
Changing the Front Axle Oil
Service Interval: Change front axle oil every 500 hours.
1. Park tractor on level surface. Engage park brake.
2. Lower attachments and stop engine.
NOTE: For draining purposes there are approximately 2.3 L (2.25 qts) of oil in the front axle. Drain oil immediately after operating tractor, when oil is still warm. It may be necessary to remove front wheels for access to vent plugs (A).
3. Remove vent plug (A) from both sides of front axle.
4. Remove drain plug (B) from both sides of front axle. Drain oil into suitable container.
5. Remove differential drain plug (C) from front axle. Drain oil into suitable container.
Law reviewer, 2018 Destroyed a good 2017 WWDC appThe new 2018 version of this WWDC app is about useless on my iPad.
It violates many of Apple’s own human interface rules!First, none of the session titles are visible (they are cut off).
![Great apps for mac Great apps for mac](/uploads/1/2/6/4/126421451/957857599.png)
M61703
6. Install and tighten three drain plugs (B and C) after all oil is drained.
7. Remove dipstick (D).
8. Add approximately 2.3 L (2.25 qts) of John Deere API GL-5 Gear Oil or its equivalent through dipstick opening.
IMPORTANT: Avoid damage! Allow oil one hour to settle before checking level. Recheck oil level after several hours of operation. |
9. Insert dipstick (D). Do not screw dipstick into case to check oil level. Pull it out.
M99182
10. Oil level should be to the top of the XX area (E) on the dipstick.
MIF
11. If oil level is low, add oil through the dipstick opening.
12. Install and tighten the dipstick.
13. Install both vent plugs.
14. Install front wheels if they were removed.
15. Tighten front wheel bolts to 133 N·m (98lb-ft).
Transmission and Hydraulic Oil
Use oil viscosity based on the expected air temperature range during the period between oil changes.
The following John Deere transmission and hydraulic oil is PREFERRED:
The following John Deere oil is also recommended if preferred oil is not available:
· HY-GARD® (JDM J20C)
Other oils may be used if recommended John Deere oils are not available, provided they meet one of the following specifications:
· John Deere Standard JDM J20D
![John deere front axle parts John deere front axle parts](https://www.compactractorparts.com/sites/default/files/product-images/John-Deere/755%20front%20spindle_3.jpg)
· John Deere Standard JDM J20C
IMPORTANT: Avoid damage! You can mix Low Viscosity HY-GARD® and HY-GARD®. DO NOT mix any other oils in this transmission. DO NOT use engine oil or 'Type F' (Red) Automatic Transmission Fluid. |
MIF
Checking Transmission Oil Level
Service Interval: Visually check gear transmission oil level every 10 hours of operation or daily.
1. Park tractor on level surface. Engage park brake.
2. Lower attachments and stop engine. Allow time for transmission oil to cool. Transmission oil must be cold to get an accurate reading.
3. Remove dipstick (A) located behind seat. Wipe dipstick with a clean rag. Install dipstick and then remove to check oil level.
M99181
4. Oil level should be up to top mark (B). Add oil if necessary.
MIF
IMPORTANT: Avoid damage! DO NOT overfill transmission. Oil expands during operation and could overflow. |
5. Add Low Viscosity HY-GARD® (JDM J20D) or equivalent.
Changing Transmission Oil and Filter
Service Interval: Change transmission oil every 500 hours of operation.
IMPORTANT: Avoid damage! Run machine a few minutes to warm oil. |
1. Park tractor on level surface. Engage park brake.
2. Lower attachments and stop engine.
NOTE: For draining purposes there is approximately 15 L (4 gal) of oil in this transmission.
3. Remove transmission drain plug (A). Drain oil into suitable container.
M61701
4. After oil is drained, remove cap screws (B) and housing (C) located on right side of transmission.
M61699
5. Pull screen on inside of housing out. Clean screen in a safe solvent.
6. On tractors equipped with power steering, turn transmission oil filter (D) (located underneath left foot rest) counterclockwise, using a filter wrench, to remove it. Some oil may come out of filter and filter base during removal. Use a drain pan to prevent an oil spill. Discard old filter and replace with a new one.
M61700
7. Put a film of clean transmission oil on seal of new filter.
8. Fill the filter 1/3 to 1/2 full with John Deere Low-Viscosity HY-GARD transmission and hydraulic oil.
9. Tighten the filter QUICKLY until it contacts the mounting surface. Tighten filter by hand an additional
1/2 turn.
1/2 turn.
10. Remove hose (E) attached to vent tube located behind seat.
M97956
11. Turn vent tube (F) counterclockwise to remove. Remove vent tube and clean in a safe parts solvent.
M99180
12. Reinstall vent tube, oil screen and cover, and transmission drain plug.
IMPORTANT: Avoid damage! Prevent contamination of hydraulic oil. Carefully clean around oil filler cap before opening. |
13. Remove fill cap (G) located behind seat.
14. Add approximately 15 L (4 gal) of John Deere Low Viscosity HY-Gard transmission and hydraulic oil. Install and tighten fill plug.
15. Start engine and check for oil leaks around filter base and drain plug.
16. Stop engine.
17. Remove dipstick (H) located behind seat. Wipe dipstick with a clean rag. Install dipstick and then remove to check oil level.
M99181
IMPORTANT: Avoid damage! DO NOT overfill transmission. Oil expands during operation and could overflow. |
18. Oil level should be up to top mark (I). Add oil if necessary.
MIF
Download John Deere Manuals pdf, In it, you will learn how to repair and operation and tests. Repair sections tell how to repair the components.with highly easy to follow step-by-step instructions & pictures on repair’s all areas, it makes repair job easy to do. Using this repair manual is an inexpensive way to keep your vehicle working properly.Afterwards, keep this john deere service manual in your Computer and ereader so you can refer to it at any time.
You’ll need a PDF tool, like Adobe Reader to open the manual. These tools are free, and your operating system will guide you to the correct program after the download. You can also use the Google Docs viewer to read the John Deere manual. Search for your specific John Deere Tractor Technical Manual PDF by typing the model in the search box on the right side of the page.
About Your John Deere
John Deere & Company was founded in 1837. It has grown from a blacksmith shop with only one person to a group company that now sells in more than 160 countries around the world and employs approximately 37,000 people worldwide. Since 1837, the company has followed John Deere’s values: commitment to product quality, customer service, honest business, and respect for individual contributions. Through continuous improvement and beneficial growth, the company strives to create value for shareholders.